How To Hang Calendar Without Using Nails

Download Article

Hanging pictures is a dandy manner to decorate and personalize a space. But there are many places where you may want to hang a picture simply tin can't use nails, perhaps considering yous don't want to get out big holes in the wall, tin can't drill or hammer through the wall, or volition be irresolute your pictures or their arrangement often. This is when it comes in handy to know how to hang pictures without nails, which you can exercise with tacks, diverse adhesive products, and other ingenious solutions. At that place are several methods to choose from, and you can determine what will piece of work best for you lot depending on your supplies and circumstances.

1
Remove hanging hardware. Agglutinative picture hanging strips demand apartment surfaces to work properly, and so remove whatsoever protruding hanging hardware that has been installed on the back of the movie.^[1] This includes nails, screws, wires, keyhole or sawtooth fasteners, or annihilation else that could make the dorsum surface of the movie uneven.
- Moving-picture show-hanging strips are a great way to put up your pictures without damaging the wall, and they're super easy to use.^[ii] Yous can find them (too as adhesive nails and hooks) at office supply stores, craft stores, hardware stores, and online.
2
Clean your surfaces. Adhesive moving-picture show hanging strips require a clean surface to stick properly, and then wipe downward your picture and the wall where you're going to hang information technology with a clean cloth and isopropyl booze.^[3]
- Allow the surfaces to dry out earlier applying the strips.
Advert
three
Utilise the strips. For each set of strips, printing the two different sides together. 1 set at a time, remove one liner and press the adhesive to the back of the pic. Continue pressing for 30 seconds. Repeat until the required strips have been applied.
- One set of strips will hold up to three pounds (1.36 kg), and near 8x10-inch (20x28 cm) pictures. If y'all only need a single set of strips, position information technology at the top center of the picture.
- Two sets of strips will hold upward to half-dozen pounds (ii.7 kg), and nigh 11x17-inch (28x44 cm) pictures. Position ane set of strips at each acme corner of the picture.
- Four sets of strips will concord up to twelve pounds (5.4 kg), and about 18x24-inch (46x61 cm) pictures. Position ane set of strips at each top corner of the film; position another set on each side of the picture, two-thirds of the manner down from the peak.^[4]
4

Affix the picture to the wall. First, remove the liner on the outside of the strips to reveal the agglutinative. So, press the picture against the wall. Slowly split the strips on the moving-picture show from those on the wall by gently pulling on the bottom corners of the picture and lifting. With your fingers, press the strips confronting the wall for 30 seconds.^[5]
5

Await one hour. This allows all the adhesive on the strips to set and dry out. When the hour is upward, replace the moving picture dorsum onto the wall by lining up the strips.

Advertisement

one
Clean your wall. Like flick hanging strips, adhesive hooks and nails require clean surfaces, and then wipe downwardly the wall with a clean cloth and isopropyl alcohol, then let information technology dry.
- Adhesive hooks or nails take adhesive backings that stick to walls, then that you tin can mount pictures using the hanging hardware fastened to the motion picture. Depending on the hardware on your picture, make sure yous purchase the appropriate agglutinative hanging equipment.
ii
Prepare the adhesive. Remove the liner from the adhesive strip and affix information technology to the claw or smash.
- Some adhesive hooks come with the adhesive already affixed to the dorsum. Skip this step and move on to the next if that's the example with the adhesive claw you accept.
3

Affix the adhesive hook or nail to the wall. Beginning, remove the liner from the back of the adhesive that's fastened to your hook or nail. In the place where you desire your picture show hung, firmly printing the adhesive hook or smash against the wall for 30 seconds.^[6]
4
Look an hour for the adhesive to dry out. When the hr is up, hang your pictures ordinarily based on the hanging hardware installed.
- Brand sure you know the weight of your picture earlier you lot purchase adhesive nails, as they mostly only hold between five and 8 pounds (ii.26 and 3.half-dozen kg), while smaller hooks may only hold one or ii pounds (0.45 or 0.9 kg).
- To hang a picture that's heavier than what your adhesive nails or hooks are rated for, use more than one. Ensure the weight gets distributed evenly by using a level during installation.
Advertizing

ane
Choose your hooks. There are several brands that make hooks that are designed to exist inserted into drywall without hammers, nails, or any other tools. These include Hercules Hooks, Super Hooks, Monkey Hooks, and Gorilla Hooks.^[7] They are made of different materials and rated to concord varying weights, but each i does crave making a minor hole in the wall. According to the manufacturers:
- A Hercules Hook can hold as much as 150 pounds (68 kg).
- A Super Claw can concord up to lxxx pounds (36.28 kg).
- A Monkey Hook can concur upwards to 35 pounds (15.87 kg).
- A Gorilla Claw tin can hold equally much as 50 pounds (22.67 kg).
2

Install your hooks. Button the long, curved (non kinked), tapered end of the claw through your drywall. Once you've pushed it near of the fashion in, position it so the small-scale hook on the exterior will exist facing upright (so that you can hang things from information technology). Set it in place by pushing information technology in the residuum of the fashion.^[8]
3

Hang your picture. Almost press-in hooks come in packs of four or more. To hang heavier pictures using ii hooks, measure the width of the moving-picture show and split it into thirds. Place one hook at the one-third mark, and a second hook at the 2-thirds mark. For even heavier pictures that require 3 hooks, measure the picture and divide it into quarters. Place 1 hook at the 1-quarter mark, one claw in the center (two-quarters), and one hook at the three-quarter mark.

Advertisement

1
Select your adhesive. Double-sided record will work to braze lightweight pictures to walls, though information technology's not necessarily designed for that job and may strip paint when it comes off. Reusable adhesive, also known equally sticky tack or poster tack, is designed to affix lightweight pictures to walls, only it can become gummy over time and be difficult to remove.
- Reusable adhesives and tapes are strong enough to concur loose pictures or posters (not in a frame), only are not designed to hold much more than i pound (0.45 kg).
- Unmarried-sided tape can exist converted into makeshift double-sided tape by taking a strip of record, making it into a loop with the agglutinative side out, and fastening the ends of the tape together to close the loop.
2
Gear up the wall. Adhesives will piece of work best with make clean surfaces, then wipe down your wall with a clean cloth and isopropyl alcohol. While waiting for that to dry, wipe downwards the dorsum of your poster or moving-picture show with a make clean, dry cloth.
- Wash your hands before handling reusable adhesive to foreclose transferring dirt or oil onto it.
3

Prepare your picture. Lay your flick face downwards on a flat surface. Press minor assurance of reusable adhesive or small squares of double-sided tape to the corners of your moving picture (on the dorsum of the picture). If you lot're hanging a larger motion-picture show, frame the back outside border with agglutinative or tape.
4

Mountain your picture. Once you've got your tape or adhesive in place, pick upwards the motion picture, line information technology up on the wall, and printing it against the wall to affix the adhesive or record to the wall.

Advertizement

1
Find existing wall fixtures. Await for hooks, screws, vents, or knobs that are already in place and that could conduct a few extra pounds. Note that this method will be about appropriate for lightweight pictures that aren't in frames.
- Look for wall features that are out of the style and that could accept a string run between them without posing a strangulation risk.
2
Tie on your string. Cut a length of string, twine, or wire that's long enough to span the altitude between the two wall fixtures, plus some extra for tying knots. Tie each stop of the cord to a separate wall fixture. You lot tin either pull the cord taut or exit it slightly loose and droopy.
- A taut string will look more rigid and uniform, while a droopy cord will look more than relaxed and artistic. The choice between the two is a affair of artful preference.
- Wire will be harder to tie than string or twine (information technology will be easier to wrap it tightly around your fixture than tie it), volition provide an industrial look, and volition allow pictures to slide around for quick re-positioning. Wire is thin and strong, merely doesn't lend itself to the droopy look.
- Twine and string will be easy to tie, can be left droopy or pulled taut, and will provide a more rustic look.Twine will exist thicker than wire or string, but stronger than string. Cord will be thinner than twine, simply non equally strong.
3
Hang your pictures. Use clothespins or clips to braze your pictures to the cord.^[9] If your string begins to sag more than information technology's supposed to or the knots won't stay tied, you may take too much weight. Either use stronger twine or wire, or tie a second string to different fixtures for a second row of pictures.
- To distribute weight and pictures evenly, place your first picture in the center of the cord using your middle or a tape mensurate. Using the commencement moving picture as the center bespeak that separates two halves, divide those halves in half over again, and place i movie at each center betoken. Keep dividing your spaces in one-half and using the center points as picture locations until all your pictures are hung.
Advertisement

Add together New Question

Question

Will any of these techniques work on textured walls?

This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.

wikiHow Staff Editor

Staff Reply

Printing-in hooks are probably your best bet. Agglutinative picture hanging strips aren't designed for textured walls—they probably won't hold long and are probable to strip off the pigment.
Question

What'south the best way to hang something heavy without nails?

This answer was written past one of our trained squad of researchers who validated information technology for accurateness and comprehensiveness.

wikiHow Staff Editor

Staff Answer

In that location are pic hanging strips designed specifically for heavy pictures and mirrors that yous can use. Merely check the packaging to make certain your object doesn't exceed the maximum recommended load. You can also endeavour heavy-duty push-in motion picture hangers, but be aware that these will leave a small hole in your wall.
Question

We are in a very erstwhile building with walls made of gypsum tile. Is at that place a way to hang art on walls without resorting to suspending it on wire from pix molding?

Depending on how heavy the pictures are, you may be able to employ the 3M Command strips. You might want to double them, hanging two side past side for added back up.
Question

How does 1 remove a command strip? Does it leave a mark?

They do not piece of work on textured walls. When I removed the strip, the pigment came right off. They may exist fine for flat paint, but don't use them for textured walls. I'm glad I tried 1 behind a door where the damage doesn't show. Now when I repaint, information technology shouldn't be noticeable.
Question

Why do I need to clean the wall?

Dirt and grit can affect the adherence of the claw or tape.
Question

Will any of these damage the wall or pigment?

Yes. Despite their advertising, these do not come off textured walls without removing the pigment. Don't waste product your coin.
Question

Can I hang a thin, 9x12 canvas on my wall without a frame? Can I use some kind of mucilage or record?

Yes. Follow the instructions in the article for the tape application. If the tape won't hold the canvas for anything just shorter periods, then use glue through the fabric and onto the tape. The tape should hold the sheet long enough for the glue to cure. Or, you lot can very slightly apply thumb tacks barely through the tape to ensure the glue'due south cure time.
Question

Tin can I utilize Command Strips on bath tiles to hang a mirror?

Yep, they work on every surface known to man -- but don't exceed their maximum weight equally stated on the package.
Question

Tin can I use Super Glue for frame hanging?

No. The glue will eventually become dry afterwards years of hanging, and fall off.
Question

I am renting and would like to hang some larger pictures on the walls without damaging the gyprock walls. What can I do?

Size doesn't affair, weight does. Foam tape or Command Adhesive Strips (many choices) used in pairs (or more) may very likely fit the beak.

Bear witness more answers

Ask a Question

200 characters left

Include your email address to get a bulletin when this question is answered.

Submit

VideoRead Video Transcript

A corkboard that's already in place or propped up confronting a wall or piece of furniture tin be used to display pictures.
Framed or loose pictures can be displayed past being propped up against mantles, bookshelves, article of furniture, or other objects, or placed in continuing frames.
Thumbtacks can be used to hang loose pictures, posters, or very lightweight framed pictures with wire hangers, as long as you can put small holes in the wall.

Advertizement

About This Article

Article Summary X

To hang pictures without nails, remove any protruding hardware from the movie frame starting time. This will allow the moving picture to exist flush with the wall once you identify agglutinative strips on the back of it. If you don't want to place whatsoever adhesives on your picture show, you can use agglutinative hooks on your walls instead. And so yous can simply hang your pictures off of this simple hardware. To learn other means yous tin can hang pictures without nails, like using tape or string, keep reading!

Did this summary help you lot?

Thanks to all authors for creating a page that has been read one,044,438 times.