How to Fix Popped Drywall Nails and Screws

Find out how to fill screw holes in drywall with this step by step guide.

Introduction

Set up drywall nail and spiral pops in 4 unproblematic steps, using drywall screws and drywall compound.

Tools Required

Materials Required

  • 1-i/4-in. drywall screws
  • Lightweight patching compound

Project step-by-step (iv)

Step 1

How to fix smash holes and spiral holes in drywall

Drive new screws

Refasten the drywall with i-ane/4-in. drywall screws. Drive the screws until they are recessed but don't break through the newspaper covering on the drywall. If you accidentally drive a screw too deep, add another screw alongside it.

The Alphabetic character 'd' in Nail Sizes

Stride 2

Cut abroad loose fabric

Cut out crushed or damaged drywall with a abrupt utility knife. Bevel the cutting and don't get out whatsoever fuzzy bits of newspaper that would exist hard to comprehend with the patching compound.

How to Use a Trim Nailer Gun

Step 4

Make full with patching compound

Fill the damaged area and the holes left by the new screws with lightweight patching compound. Apply a flexible putty knife to utilise the chemical compound and smoothen it. Utilise two or three coats, assuasive each to dry completely before recoating.

Popped drywall nails and screws are common in old and new homes alike. Information technology's tempting to just pound the fastener back in and fill the divot. But this is a brusk-term solution. To permanently gear up the problem, drive a new smash or screw to reattach the drywall to the framing and remove or bury the old fastener. Don't be scared off by the extent of damage in the photos. This is an extreme case where the nail pop was made worse by an overzealous drywall installer. In situations like this, the crushed drywall must be removed before you fill the hole.

We used lightweight spackling compound to fill the damaged area. Information technology dries quickly, doesn't sag and is easy to sand. Expect to apply ii or three coats to cover a pigsty this large. The drying fourth dimension between coats will depend on how deep the hole is. Use a fine sanding sponge or 100-grit drywall sanding paper to sand the patch before priming and painting.

Set and Nail Decking Perfectly

Originally Published: Jan 25, 2019